Anniversary Ticker

Daisypath - Personal pictureDaisypath Anniversary tickers

November 9, 2011

Burnt Edge Pillow

Continuing on my pillow kick since i am making all the pillows to finish my bedroom set. I used this tutorial for the flowers i places on the pillow. http://www.simplyvintagegirl.com/blog/index.php/2010/05/29/tutorial-how-to-make-lovely-fabric-flowers/

If you haven’t used those tea lights in a while, now’s the time! I hope you enjoy making these as much as we do . . . below are instructions with pictures on how to make your own.
Fabric Flower Tutorial: Supplies
Supplies:
· Synthetic Silky Fabric
· Scissors
· Candle (preferably a tea light)
Additional supplies:
· Needle and Thread, Glue Dots or Glue Gun
· Buttons and/or Beads
Directions:
Fabric Flower Tutorial: Step 1
1. Cut circle patterns out of card stock. ( i used cookie cutters i already had that were different sizes)

Make the largest one’s diameter about half an inch larger than you want the diameter of the flower, as the petals will end up shrinking a bit. Create a few of these, lessening the diameter bit by bit so that the end result has smaller petals in the center and larger ones around the outside. You can also use a pattern here, which works very nice!
Fabric Flower Tutorial: Step 2
2. Trace around the pattern onto the silk fabric (using a pen).

You can also cut around the pattern and skip the drawing part, it just might not be as uniform . . . but with these, uniform isn’t necessary. And if it’s not uniform, it adds character. And character is good.
Fabric Flower Tutorial: Step 3
3. Take the scissors and cut out the circle and petals.
Cut just inside the drawn lines to make a circle out of the fabric. Carefully cut only about a third of the way into the circles to create the petals. You can do as many or few petals as you would like, or even add some variety to them. I cut five times, making five medium-sized petals. You can also round the corners of the petals, if you so desire.
Fabric Flower Tutorial: Step 4
4. Use the lit candle to melt and crinkle the edges.
Be very careful (please have adult supervision, this is rather dangerous), as it is very easy to get burnt. Hold the cut petals about one to two inches above the flame, making sure to keep the circle rotating so that it does not overheat and catch fire. Continue to gently melt the edges of each petal until you have gone all the way around. Do this with each layer.
Fabric Flower Tutorial: Step 5
5. Sew (or glue) the petal layers together. (glue guns are my favorite!)
Using a needle and thread, create a beginning knot and then sew the layers together. You can come up through the top because the center  of the top layer can be covered by a button or  bead. To finish the flower, sew (or glue) the button or bead on top.
If you would like to add extra stability to the flower, you can sew or glue a piece of felt onto the back (make sure it is large enough to give good stability, but small enough so that it won’t be seen from the top).

After i made about 8 flowers and assembled them together i quickly threw together my pillow case. Using the same few steps from this post 
I love the colors all together and am so glad with how this pillow turned out! 6 dollar pillow insert and about 4 dollars worth of fabric!! AWESOME!

No comments:

Post a Comment